Help please. This 7 yr old dishwasher is not draining at the end / beginning of the cycle. I checked both filters which were clear. Disconnected the drain line to the sink and it was clear. Pressed the 2 buttons together for 3 seconds per manual to reset. Turned off circuit breaker to reset. Nothing helped.
This happened 2 yrs ago and I believe the circuit board was needed and was replaced. When you start the machine you hear a slight hum for 20 seconds before the wash cycle. Any suggestions would be greatly appreciated.
Try looking for slithers of glass etc under the impeller. Remove the sump covers (filters) and look into the bottom. There will probably be a small cover held down by a screw. Under this is the impeller. Roll up a hand towel into a cigarette shape and slide this under the impeller - that should clear anything out.
2,396 views
Usually answered in minutes!
I have a SHU6805UC/U06 which also does not drain completely after a full cycle. The water stands at the bottom and begins to stink. I have cleaned out the filter and cannot figure out why the water is just sitting.
I'm having the exact same problem. I think it happened once before and I was able to get it going with a Cancel/Drain, but no luck this time. I've also been unable to find any blockage. It seems as though the Drain cycle just isn't running.
×