I turn the power on and it tries to start. There is no picture and the fan runs a little bit. After about 30 seconds, the green timer light turns off and the red status light turns on. I've tried changing the bulb with the same results. When reset, the green light flashes and goes out but when re-powering, results are again the same. I've tried disconnecting from the power for several days, same problem. The owners manual said to take it to a service rep. I am hoping to avoid that cost and challenge. Any advise? Thanks.
green power light comes on, them after a couple of minutes the status loight turns red - no picture.green power light comes on, them after a couple of minutes the status loight turns red - no picture.
AnonymousMar 17, 2014
green power light comes on, them after a couple of minutes the status loight turns red - no picture.green power light comes on, them after a couple of minutes the status loight turns red - no picture.
You can't post conmments that contain an email address.
Hi we have a 52 inch mitsubishi high definition tv and ours did the same thing,we had a repair man out here and he said it was the engine in the tv which we never knew tv's had engines so i contacted mitsubishi cause we didn't take a entended warranty and told them that it was not even 3 yrs old and they should stand up to there products and they did they paid for the part which was 600 dollars and we had to pay for labor....we thought it was the light to and ordered one and it wasn't it was doing the same thing yours did .....
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Five blinks - AKB
circuit (automatic kine bias), the timer/standby indicator blinks
for about 30 seconds then goes to the self-diagnosis function.
Something is wrong with the video. Check video out, Q705, 732, 761
and other components on the C board, also check Q218, 219, 220 on
the A board. In addition, unit could be in IK blanking, try turning
up screen A2 slightly.
Both power light and status light a solid red with no response to any buttons indicates the bulb timer has expired. You need to reset the timer by pressing and holding the left arrow key, the right arrow key and the power button all at the same time for a few seconds.
If there are no problems, the projector will fire up, but you must replace the bulb as it will fail soon and perhaps explode when it does.
green power light comes on, them after a couple of minutes the status loight turns red - no picture.
green power light comes on, them after a couple of minutes the status loight turns red - no picture.
×