I hve an edlna quilters choice that has a problem. my grandson did computer research and in checking the machine got to where it indicated the pedal motor was not working. Can this be repaired?

Hassy

• 1388 Answers
• Posted on Aug 23, 2009

SOURCE: Can you use Maxi-lock cone thread on the baby lock

Choice of thread is entirely up to you.
If it is a fancy dress use once affair, cheap is fine. If you want a robust result that will last, then use quality thread, if you go to all that trouble, why skimp on the one thing holding it all together ?
Maxi Lock sounds like Serger/Overlocker thread on a large cone, it will be thinner than standard thread and you may also have tension issues in bobbin abd top tension,

SOURCE: I have a white quilter's sewing machine, model

Hi, follow the instruction below to troubleshoot the foot pedal

• Unplug the machine plug and wall plug on the sewing machine.
• Check the power cord for cracks, burns, or faulty contacts as this could be a possible reason for the foot control not working.
• Open the foot control by using a knife or flat surface tool, such as a flathead screwdriver, to pry open the corner of the foot control.
• Check the wires to see if they are disconnected; this can happen if the foot control drops to the ground. To check wires, remove the circuit board using a flat knife. Inspect the wires inside the foot control. You will see some wires that are soldered together. Check to see if there are any broken wires, as this could be the problem. If the wire is broken, clean the area to remove any debris or dirt. Remove a small amount of the insulation before soldering. Solder wires together.
• When you are done, reassemble the foot control and make sure it's working again.

SOURCE: Thread is bunching up on

My thread is bunching up on bottom of fabric and loose on the top, not sure when I am embroidering on my Baby Lock Essante machine, it just started, why?

SOURCE: how do I get a new sensor board for my baby lock sewing machine?

take it to a sewing machine shop & they can order one & put it in