Question about Whirlpool Washing Machines
At times have to open and close the door several times to start the machine. Cleaned strainer out at bottom and the ball in the black rubber hose at the bottom is free and clear. Only issue is the water left in the tub which happens about 20% of the time
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Welcome to fixya.com
I'm Huuum and happy to assist you,
Try this first and if it fails to remedy the problem then call service as you wanted!
Huuum At your service!
With an error code.
This can reset the system.
First unplug the washer and wait a 5 minutes then restart it.
If you can't reach the plug, use the breaker to cut the power for 5 minutes.
It's like rebooting your computer when its acting strange!
Usually it corrects some error problems if they are not serious.
Or they are sometimes just a glitch.
let me know how it works out.
How old is the appliance?
Let me know how you progress!
Bless You, Huuum
Please remember to leave a rating when you are finished!
Posted on Sep 23, 2008
sounds like a bad water inlet valve stuck open and permitting watertto enter even though not on, untill you replace the valve turn off water between uses part number 8181694
Posted on Oct 31, 2008
i would try to clean the trap out at the bottom, there is a panel on the bottom take that off and clean out the trap, it looks like a turn dial, something like that has happend to me, it cant hurt to try
Posted on May 28, 2009
1. Remove the lower panel under the door by loosening the three screws
under the bottom edge on the front of the washer. HINT: If you prop up
the front feet of the washer with some small blocks of wood, this will
make access to the screws much easier.
2. With the screws removed, the lower panel should drop down then come off. If the panel sticks, a light tap on either side will knock it loose.
3. Reach your hand up inside the washer behind the front casing on the right-hand side. This is where the door latch assembly is located.
4. At the bottom of the door latch assembly is a small pull tab. This is the manual release for the door. Pull the tab straight down and the door will come open.
Sometimes these doors will not unlock for whatever reason. If there are no error codes being generated, this could have just been a momentary glitch. If you see "Fdl" or "Fdu" error codes, these are usually indications of a failed door latch assembly and will require replacement.
Posted on Aug 01, 2009
Tips for a great answer:
Jun 04, 2016 | Whirlpool Duet GHW9150P Front Load Washer
Nov 06, 2012 | Whirlpool Duet GHW9150P Front Load Washer
Aug 10, 2011 | Maytag Centennial MTW5800TW Top Load...
Dec 06, 2010 | Whirlpool Duet GHW9150P Front Load Washer
Jan 13, 2010 | Whirlpool Duet GHW9150P Front Load Washer
Mar 22, 2009 | Whirlpool LSR5132PQ Top Load Washer
Dec 14, 2008 | Whirlpool Duet GHW9150P Front Load Washer
Nov 09, 2008 | Whirlpool GHW9400 Front Load Washer
63 people viewed this question
Usually answered in minutes!