Where is the fuse at on the 8750 watt portable generator

SOURCE: Coleman Powermate 8750 will not generate electricity.

my name is scott i work on generators,i realy need more info so ill give u some basics
................1] need to check your brushes u can get to this on the back side of the motor,by tacking out the 4 bolts or depending on the cover a 1"x3" plate
................2]if that is good then i would test out the field or armature

p.s. all of this is done on the motor not the engine, also u may also want to talk to tech support at PRAMAC,this is the suplier for coleman/powermate

mamicheddy

• 79 Answers
• Posted on May 08, 2009

SOURCE: I have a Generac portable generator 5000 watts, won't start!

I am assuming the generator worked fine before the oil change. Now that you have done the oil change the genset does not start. These generators have a safety switch, which is basically an oil pressure switch that keeps the engine from running when there is not enough oil in the engine. Make sure that there is enough oil and if there is, look for a wire that runs along side of the engine to a round component. disconnect that wire and try starting. If it does not start then try to ground out the wire to the engine block. If this does not work, then there is other engine problems.

Mike Butler

• 6674 Answers
• Posted on Jul 20, 2009

SOURCE: portable generator pops breaker when temp is over 75 degrees

I take it you have RV plugged into generator. Hopefully direct with no extension cords. Are you using a 30 to 15 amp adapter to plug into generator? What is the rating of the breaker on the generator that keeps tripping, suspect it's only 15 amp?

SOURCE: use a 7500 watt transfer switch with a 8000 watt

There is no problem to use it if the load to be transferred is under 7500 W.

Even a load of 8000 W may be handled for a short time, but if the protection of the switch is adjusted at 7500 W (the respective current), it may drop after some time.

SOURCE: Guardian 15000 Watt Portable Generator

Suggest you go to Amazon.com and do a search for the Generac Guardian. When you find it, look in the product details and you will see Product Manual (PDF) under the Product Details.

http://ec1.images-amazon.com/media/i3d/01/A/man-migrate/MANUAL000031765.pdf

it has a troubleshooting guide located on page 19.

No Battery Charge DC output.

1. Battery posts are corroded. 1. Clean battery posts.

2. Battery cable is bad. 2. Replace cable.

3. Battery is defective. 3. Check battery condition; replace if

defective.

4. Receptacle is bad. 4. Contact Authorized Service Facility.

Hope this helps!