Worn out drum Bearing can cause vibration and make the spin cycle very noisy.
Testimonial: "Thank you for your answer to my question. i gotten a few answers that really sound involved. going to check out your idea and see where it takes me.Thanks again. Lynn"
Sorry just saw your answer. Thanks for the input. The machine was working great no vibration at all. Then on a load of towels it was spinning unbalanced. I stopped it as soon as i heard it and rearranged the towels and restarted it. It worked fine for the rest of the cycle. Then it happened again a few loads later. The vibration sounds like it's bumping on something the faster it goes the less noise it makes. Could it be that the off balanced load loosen a belt? I haven't looked inside yet. We'll see.
Lynn
Ok, some machines have shock absorber(s) fitted to outer drum to reduce vibration.These sometimes need replacing.
Start getting paid every month online from home more than $15k just by doing very simple and easy job from home. Last month i have earned $17954 from this online job just by giving this 2 hrs a day using my laptop. I am now a good online earner. Get this job you guys also and start earning money online right now by follow details here......................===>>>www.gocash7.com++
Don't copy "++ " with web address
×
SOURCE: maytag neptune front loading washer
purely based on the vague information you have given, this could sound like the drum bearings and the fact that it has been neglected for so long has resulted in serious damage to your machine, note to all, never continue to use machines making noises, it can only get worse and do mare costly damage, after all the problem could have been a very inexpensive fix problems on this and any other site, to be fixed by messages (without actually seeing the machine) can only be fixed - or advice can only be given based on the details that are given if you say my machine just stopped then you will not get an answer will you? engineers can help sort out lots of problems without seeing the machine if we are given the right DETAILED information, no matter how silly it sounds, so before you shout and complain at others, have a thought about what you are going to write sorry its bad news but i hope i have helped
SOURCE: Front load washer shakes violently during spin cycle
I had this problem as well.
I called dealer and Maytag.
They made an appointment and stood me up several times.
I finally went to place that sells refrigeration equipment and bought an anti-vibration pad.
It's a 12" square waffle pad used under large equipment to prevent them from vibrating loose on connected piping. I cut it into 4 pieces and put one under each corner of the dryer.
Problem solved, in fact it worked so well that I stacked dryer over washer, placed pads between units and have not had a problem since. I also gained a lot of space in my laundry room as well.
SOURCE: Front load washer shakes violently during spin cycle
On something like this you will need to remove the washer wrap to inspect the suspension springs & base assembly. Please see the link provided for accessing the inside of the washer. Be sure the shipping pins have been removed. The tub should float freely.
SOURCE: major shaking during spin cycle
I have the exact same washing machine with the same problem. It is a poor design and Maytag knows it. We should be entitled to a refund. This was a very expensive machine.
SOURCE: Maytag Neptune Front Load Washer Model MAH4000AWW low last spin
two problems here,
your shaft seal is running on its last leg
the sound is unmistakeable and always described the same...
the water issue, you probably have a trickle leak through the cold water valve
the mixing valve is quite an easy repair, but I would have to say with all honesty, it probably time for a new machine
the hub seal is a tub replacment call
2 hrs of labor if hes good
and the tub runs around 500.00 dollars
sory for the bad news
2,492 views
Usually answered in minutes!
Start getting paid every month online from home more than $15k just by doing very simple and easy job from home. Last month i have earned $17954 from this online job just by giving this 2 hrs a day using my laptop. I am now a good online earner. Get this job you guys also and start earning money online right now by follow details here......................===>>>www.gocash7.com++
Don't copy "++ " with web address
Every month makes more than $18k by just doing very simple job online. Last month i have earned and received $19649 from this online job by doing this for only 2 hrs maximum a day using my laptop. Very simple to do regular job and earning from this are just amazing. Everybody can get this now and start earning online by follow details on this website........
HERE? www.profitclip.com
That's really great. I like answering random questions for people. I don't consider myself an expert on anything. But like to share what i do know if i can. Was it hard for you starting out to talk to people? The only reason i haven't started answering questions on the phone is What if your wrong or maybe only able to help with part of a problem? There's a certain safety of typing your answer over actually talking to some one. On the computer you can research your answer if you need to at the same time. Anyway looks like your making good money. Maybe after the holidays ill finish my profile and give it a shot. Happy Holidays.
Lynn
×