My john deere riding mover the clutch will not disengage it still keep going.any solutions

Please refer to this site for details on trouble shooting manuals. I am hoping you are after John Deere tractor lawn movers etc.

Troubleshooting

you could put a batter disconnect switch inline-but replacing the clutch is going to be your best bet-cheers Denny

Check the spring for the clutch.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

This is common for the 70 series.Clutch dics are stuck together,just short of splitting tractor you have to hit a pile of dirt with loader bucket to see if you can break it loose.

Are the blades turning? If they are not, this is normal. The PTO is an electro magnetic clutch that engages when you apply electricity via the PTO switch. When it is disengaged, the bearings and top portion of the clutch will turn because it is coupled to the engine. If the blades ARE turning then you have a bad clutch and will need to repair or replace it

yes. your mower has a blade engagement cable attached to the drive sheve. i am providing a link to the manual which shows this.

http://manuals.deere.com/cceomview/OMGX22464_C8/Output/Index.html?tM=HO

its actually the clutch not disengaging enough for pto to engage or the teath are worn down on pto shaft

It sounds like the seat switch is disconnected or failed. Check it out. If it thinks there is no **** on the seat it will cause your symptoms.

The PTO usually has a clutch that has to be engaged so that you can select the PTO rotation setting. I had a problem like that on my tractor and all it needed was a little adjustment on the PTO clutch lever, so it could disengage the PTO gearbox properly.