What is error message efo - AEG Lavamat W1050 Front Load Washer

E10/EFO error code is an indication of a slow fill, took to long to fill, no fill or the fill water could be siphoning out the drain hose as it's filling with water.

Check to make sure that the drain hose is not stuck too far down the stand pipe and causing the water to siphon out. Check the cold and hot water supply to the washer for any restrictions. If you have a slow fill remove the hoses from the washer and check for restricted filter screens in the water inlet valve. Check for any restricted hose screens too.

Hi,
EFO error is a water leakage error.You need to call for service.
Thank you

efo enter prblem what is the problem

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

spoke with electrolux and they tell me that it is over sudsing problem. The washer must use HE detergent or use only a the lowest amount on the cup.

Clogged drain pump.

I don't see either of those error codes in the frigidaire technical data for this model. You can look here:

http://www.frigidaire.com/support/ResultsPage.asp?strModel=atf6000es&User=&Search=Search

I've heard EFO has to do with oversudsing so if you're using HE soap use less, if you're not you should switch.

It is simple. The wrong soap or too much soap will caused EFO to flash. I overfilled the machine with soap by accident. It started flashing with EFO and I went nuts. What could be wrong with it now?! Too much soap or not the right kind of soap will cause this problem.
Plus, I found a sheet of paper that gives the codes.

This is better than when the strainer plug gets filled up and you have to take the machine apart to clean the little strainer.