Washer won't drain or spin

Either the drain hose is or the pump could be clogged or plugged.Or it needs a new drain hose or a new pump for your washing machine.

most likely pump got plugged. remove and clean.

Pcboard mulfunctioning

There are many things that can stop it from spinning....but the
first place to check is the belt. Is it loose or broken?

hi
unfortunately the programmer is faulty

What is the complete model number of your unit?

What water temp do you wash on and what water temp for rinse?

Good deal your machine is a Series 11.

“”Washer has stopped at 26 min with water in the drum. Will not spin or drain. Just sounds like it starts running then stops and repeats.””

I believe this is the start of a Spin Cycle of that Wash Cycle which Wash Cycle did you have selected?

Are there any error codes to the LED display like dC or uC?

If you stop that wash cycle with the wet load and do a Spin Only cycle will it complete with no error code?

Does the wash tub bang around in Spin Only cycle with the wet clothes load?

Standing by for some feedback and I will try to help.

Here is the Service Manual and parts look up. Can you let me know if you want to try to DIY the fix?

FAV6800A/FAV9800A Service Manual for reference. Sears Parts Direct for reference.

Rich

since you can drain it
take off the back and watch what happens when u turn it on
i believe you make have a loose drain connection

Solution for Washer Kenmore 80series stopped on SPIN CYCLE and no Drainage or motor running.

** What was stopping it to drain was the defective limit switch which when the cover lid is closed starts the spin and the drain at the same time. I jumped the wires to get my close washed and I have to replace it for security. I had to unscrew the front control panel and remove the casing that wraps around the washer to have access for the limit switch wireing harness. I cut the two black wires and joined them with a wirenut so that I was able to continue my wash and draining the water leftt over.