Mantis 2-Cycle Tiller Logo

Related Topics:

Posted on Feb 26, 2009

Mantis tiller sv-4 echo engine: no spark from coil

Is there away to test coil ? have remove wir from kill switch still no spark

  • Anonymous Mar 31, 2014

    started up after being stored in a warm room all winter, but won't stop unless I remove the spark wire

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 12 Answers
  • Posted on Mar 21, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Mar 21, 2009
Answers
12
Questions
0
Helped
18317
Points
49

There are only 4 parts to the 2-stroke Mantis ignition system: the spark plug, the "kill button", the flywheel with embedded magnets, and the coil with integral plug wire. There are no "points" to clean or refurbish. If you've tried a new spark plug, unplugged the wire leading up the handlebars, and the magnets on the side of the flywheel are strong enough to attract a screw driver blade, then it must be a bad coil. That's all it could be. End of story.

Cruising the internet I see where these Echo coils go bad all the time. You can order the coil, but if the machine hasn't run in several years the carb will also need cleaning. So one thing leads to another. The gear box grease also needs replacing each year. What I'm trying to tell you is these are disposable tillers and due to length of time, incomplete care/ storage, ....whatever, this one's time is up.

Sorry.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Where is the engine number on mantis tiller an old one

In the Mantis 2-cycle tiller:
SV number is located between the gas tank & the carburetor, behind the gas line, on a black and silver tab on the silver engine housing. It will consist of the letters "SV," a number and another letter.
0helpful
1answer

No spark on sr230...got suggested new plug ngk...unit was hardly ever used.

The best test for an ignition coil is removing the wire(s) going to the kill switch at the coil. Most small engines will run with the kill circuit open & stop when you ground it. If you disconnect the kill wire & you have no spark, than it's a coil.. If you do have spark, check the switch & kill wire for a short
Sep 22, 2010 • Echo Garden
0helpful
1answer

Yesterday it quit running after performing normally for about an hour. Now I cannot get it started. Motor turns over easily, but won't fire.

If you have the 2-cycle Mantis tiller, it uses the ECHO engine. ECHO warrants the ignition coil for life to the original purchaser. If you have VERIFIED there is no spark at the plug, grab you reciept and head for your local ECHO dealership. If you aren't sure where one is and need to locate a Servicing Dealer, click HERE.

Hope this is helpful,
Dolf-
0helpful
1answer

Mathis tiller sv-4 engine no spark form coil

clean and adjust the ignition points.
3helpful
1answer

I Have a Mantis tiller that I can get NO spark

set the coil to the thickness of a dollar bill from the flywheel and tell me what happens. make sure kill wire isn't grounding somewhere else
0helpful
1answer

Mantis tiller sv-4 echo engine no spark from coil mantis 2cycle tiller i got it running tryed to start it 4hrs latter same old problem wont start, plug wet with gas wont start. coil was checked by shop...

Sounds like it's flooding either from over choking or the inlet needle in the carb is leaking. Have you removed the plug and blown out the cylinder and plug with air and then tried to restart? Be careful not to keep cranking with the choke pulled out. When it 'hits' ONE time, move the choke halfway in and crank again
0helpful
2answers

What is left to do but change the flywheel?

check what they call air gap between the coil and flywheel .010-.012 gap
also be sure your flywheel is in time.
you will actually have to remove it to do this and check for the sheared key or be sure the key way aligns with the crankshaft keyway on the flywheel
1helpful
1answer

Item: Mantis Tiller Problem: wire to kill switch came loose from where it attaches under the cowling covering the engine. Question: where does it attach, I need to reconnect it

Hello:

The Shut Off Wire is Attached to the Ign Coil.
There is a Spade Lug on the Coil that the Wire Attaches to.
Hope this Helps.

Good Luck

Respectfully

John
Not finding what you are looking for?

5,839 views

Ask a Question

Usually answered in minutes!

Top Mantis Garden Experts

john h

Level 3 Expert

29494 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Mantis Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...