20 Most Recent
Summit SPWD1800 - Page 8 Questions & Answers
The 19 kg washer has a start light flashing but does not do wash after the current went and returned
It seems like your washing machine is experiencing a common issue after a power outage. This could be due to a disruption in the machine's cycle. To resolve this, try the following steps:
- Reset the Machine:
- Turn off the washing machine and unplug it from the power source.
- Wait for a few minutes (around 5-10 minutes).
- Plug the machine back in and turn it on.
- Check Door Lock:
- Ensure that the door is securely closed and the lock is engaged.
- Restart the Cycle:
- Select the desired wash cycle and press the start button.
If the issue persists, it might be helpful to consult your machine's manual for specific troubleshooting steps. Additionally, power fluctuations during the outage might have affected the machine's electronics. If the problem continues, consider contacting the manufacturer's customer support for further assistance.
Remember, power interruptions can sometimes cause electronic appliances to behave unexpectedly, and a simple reset often resolves such issues.
The blades will not go around. How can I fix this?
The 'blades' on your washing machine? It is called an agitator. Make sure the bolt is tight. If it is it is probably the clutch. There is indeed a washer under the bolt head.
'make model (what it is)' in all questions first 3 words.
There are over 40,000 categories to choose from.
..
It has 2 and lock will not start
'make model (what it is)' in all questions first 3 words please.There are over 40,000 categories to choose from.Googlemake model lock symbolormake model manualIt may be the child lock, so look for that in the manual..
My Hisense fuzzy washing machine WTQ1602S is not spinning just give an E3 code
An E3 code is the machine detecting an issue with the machine not draining water correctly. Unplug the machine from the main power supply then remove and clean all the filters on the machine. The washine machine can reset if left unplugged for at least 15 to 20 minutes. Unplugging it first then cleaning the filters will take at least that amount of time.
Hoses are connected correctly. Only hot water. Turned hot water valve off and hot water still ran instead of cold. HELP
Backflow from convection and from expansion of water in the hot water tank is pushing heated hot water backwards, into the cold water supply line, wasting that heat. Install a backflow preventer. A quick test for that issue is to partially throttle the water entering the heater, but do not reduce it to a trickle, let the tank overheat and be damaged! If water in the outside tap is now noticeably cooler, backflow is at least one culprit. Reopen the heater valve after testing!~
My washer is doing the same. It will not agitate or spin. The door switch and fuse link are okay but no power on red/white wire.
Your washer is doing the same as what? No context.
Click EDIT on your post and remove "My washer is doing the same." Replace with 'make model washing machine'.
At this point no one knows what the red/white wire goes to? If it goes from the control board to the motor controller, it would suggest the board has failed. They are expensive, so I always recommend professional diagnosis so you get warranty on the part and the repair.
If the motor was humming, not clicking, it would suggest the start/run capacitor need replacing. 'Clicking', sounds like it is a motor controller.
Not finding what you are looking for?