20 Most Recent Kenmore Elite 21086 - Page 6 Questions & Answers

Had same problem mine was the yoke thatheld inner drum tobearing was broken. Lucky it was covered by Sears warrenty. Over $1,000 to repair without warrenty..

Need to reset the program and see if there is fault in the water line that does have a low flow and so the program cycle gets a error due to time taken for the rinse cycle.remove and clean the inlet and the drain pump and hoses.

I hope this answers the info you need. http://www.acmehowto.com/howto/appliance/washer/check/waterlevel.php

you either have to bail it out our remov e the hose at the pump and carefully drain it into a bucket. it could be you have a bad pump or a kinked drain hose.

That code means Door lock failure. You will need a service tech to diagnose the exact problem.

check pump or belt , also make sure not to many clothes are in tube to prevent it from spinning at a high rate .

Check out the link for Kenmore Parts suppliers. https://www.google.com/search?q=Kenmore+series+200+triple+action+agitator+parts ..

If it is only leaking when you use warm water it is likely a leak from the delivery side of the hot water inlet solenoid. The only way to check is to remove the top and look. https://www.google.com/search?q=Kenmore+80+series+washer+92281100+leaks ..