Kenmore 24032\24036 Top Load Washer - Answered Questions & Fixed issues
Washer fills slow only in the rinse cycle
I had the same problem with my Kenmore Model 11022956102 washer and first thought that it was the water inlet valves. So I replaced them, but found the problem continued. After about 25 seconds into the rinse cycle the water only trickled in. Checking with a voltage meter I found that I lost 120V at terminals 3 & 5 on the washer temperature controller after 25 seconds. Even though the wiring diagram doesn't show the water temperature control board, since it's full of resisters and capacitors, I figured it was the most likely problem. So I ordered a remanufactured board from Parts Simple (#3407125), received and installed it. The 17 year old washer is now working fine once again. I hope this helps someone with the same problem. /s/ Paul
8/23/2022 11:24:48 AM •
Kenmore...
•
Answered
on Aug 23, 2022
•
972 views
Baby clothes under the ringer
Loosening top plastic nut and removed top 1/2 of agitator, then loosened nut to lift out bottom 1/2 of agitator.
6/27/2019 3:47:39 PM •
Kenmore...
•
Answered
on Jun 27, 2019
•
1,274 views
Washer fills, but not agitating or draining
If the lid switch is faulty, or incorrectly adjusted, the drive motor is prevented from running. You do not say whether your repair man replaced the switch or the mechanism, but draining and spinning will only happen when the lid switch is engaged.
3/2/2018 6:06:26 PM •
Kenmore...
•
Answered
on Mar 02, 2018
•
130 views
My kenmore washer model 110.27802690
Under the lid there should be a small hole with a push down flap and that should be the automatic stop, which can either be a bad switch under the top of the machine or could be a broken trip/ prong on the lid that pushes this button when the lid is dropped. When the machine reaches it's spin cycle time leave it turned on and raise the lid push down on this flap with something careful to keep hands out of the washers tub and see if it works then!
3/2/2018 5:50:59 PM •
Kenmore...
•
Answered
on Mar 02, 2018
•
393 views
I have a Kenmore series
Just clean the filters off bluffs or coins and if not check the pump.
1/10/2018 5:46:15 AM •
Kenmore...
•
Answered
on Jan 10, 2018
•
149 views
Spin cycle will start then stop then start again then stop
I bet your problem is in the timer control. There is a piece of cardboard that can be easily removed. You can then see metal extension rods with contacts attached. These rods can be adjusted so the contacts can make better contact. Here is a link to help you better understand. https://youtu.be/pdiDGySo3uI
11/5/2017 7:32:27 PM •
Kenmore...
•
Answered
on Nov 05, 2017
•
199 views
I have a Kenmore Elite
I expect you will need to dismantle first and examine each part as it is removed and make a list.
Your description indicates at least a main bearing problem but with what seems to be such a complete failure there is certain to be "failure-related damage" to consider.
10/23/2017 4:08:25 PM •
Kenmore...
•
Answered
on Oct 23, 2017
•
361 views
70 series top loading washer
probably no parts for a machine that old
consider getting a new unit that is more power and water efficient
6/25/2017 11:52:41 PM •
Kenmore...
•
Answered
on Jun 25, 2017
•
97 views
Not finding what you are looking for?