20 Most Recent Frigidaire FFLE1011MW Electric Washer/Dryer Laundry Center - White - Page 7 Questions & Answers

Try unplugging for 5 minutes

It is not removeable.

Yes at 22 years old its going to break. Buy new. Tge tub is no longer available for that

Give the drum a spin to see if it's bound up. If no resistance, it could be that the drive belt snapped.

It’s connected to drain pump in bottom of machine. You’ll have to determine what has to be removed to access pump.

Frigidaire Affinity Washer Error Code E41 = Control board thinks the door switch is open. Usually replacing the door switch fixes and clears the error code.

waste water outfall pipe blocked or kinked.......... cheers

yes it can, but no one can tell what parts are needed as they are not there to look at it. best solution is to call for service.

On occasion, the manufacturer will in include paperwork inside of the back. You would have to remove the rear cover or panels.

Any error codes? Drain pump may be blocked.

Sounds like the water pump seal may be leaking.

Does this machine have the 'old style' mechanical control timer unit the you rotate the dial? If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Jason, take a look at this link and follow the steps very carefully. Were insulated golves. How to Fix an LG Front load washer machine that wont spin

This sounds like a similar fault I repaired on a Fisher Paykell top loader smart drive. It would fill up, start it's wash cycle (you'd hear the engine turn back and forth ) and a second later stop. It turned out that a position sensor on the motor had failed due to a small water leak. I'm unable to find the motor for your model of Frigidaire to see if there is a similar sensor or pick up module though.

I don't understand SHANE circuit board. IF you replaced the board, it has been upgraded and you need to order a new wiring harness for it. Please post the model number