20 Most Recent
Frigidaire FFLE1011MW Electric Washer/Dryer Laundry Center - White - Page 3 Questions & Answers
My frigidaire water filters is stuck. When i push it in, it wont release. How can i remove it?
I had the hardest time getting the old filter out...nothing worked for me; it wasn't frozen with ice as one video suggested, it was just physically stuck. Pressing in I couldn't get the rear latch mechanism to let it go. (even after removing the housing) I ended up:
1) turn off water pressure (maybe this helped some?)
2) removed the 4 screws holding the mounting mechanism to be able to get to the latch that holds the "rooster comb" of the filter.
3) took a hemostat and moved up the latch while pressing the filter in (a bit tough now that bracket wasn't mounted, so nothing to push against
4) it finally came out.
One of the plastic clips on the "rooster comb" actually broke on the filter side, it was likely jambed so I couldn't remove the filter. The replacement filter doesn't have the full "rooster comb" instead just one piece of the "comb" but it seems to hold in place fine, maybe will make it easier to remove (didn't want to tempt fate trying to remove it after I got it in place).
So...I'll try buying a filter that has just one piece comb. Also, the one that stuck had this comb on a slide mechanism that goes up and down (relative to top/bottom of refrigerator) but the replacement has it fixed with no slide...it could be that the slide movement actually contributed to it being stuck, since the mounting plate in the refrigerator also slides up/down in same direction (not sure why 2 pieces both slide, maybe if spring in mounting plate were stronger it would work better but in lieu of changing out the $40 mounting plate, I'll see if this "one piece" comb allows it to be removed with less fuss.
How do I repair a washing machine?
Common solutions for: Frigidaire Washer won't spin or agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it. If the lid switch assembly fails, the washer will not spin.
Errant earring
assuming this has long since been dealt with, but if its not in the rubber gasket at the front of the machine, take off the bottom panel at the front, there is a small pump there that drains the unit. It may be trapped in there. You can use pliers or vice grips to remove the couplers holding the hoses on and a screwdriver to remove it.
I can't get the "loc" display to reset from my Frigidaire gallery dishwasher
Try pressing and holding the Delay Start button for ~3 seconds. The 'loc' indicator should go out. If you hold the button for too long, then the lock could toggle back on. If the problem persists, you may have an issue with the keypad on the dishwasher.
I hope this helps. Please add a comment with the model number of the dishwasher if the control panel lock does not disengage.
Cindy Wells
Not finding what you are looking for?