cant get it close enough to start the tiller to adjust it... set low speed jet to 1 turn, highspeed jet 1and a quarter this should start ya off tweek from there.
...runs smoothly at high speed.Alway use the "lightly seated" method if you have not changed the screw settings.Please take time to rate me ...
what is the main jet setting for a 8 horse tecumseh motor start at 1.5 turns and work your way out until you get a smooth run
set up or did the carb go bad i have gas going to the carb thank you Hi and welcome to FixYa, I am Kelly. I think you just have debris in the float bowl and the jet where the bowl nut threads into the
Backfiring engine on start up Only backfires on start up about once every 10 starts. Very loud pop. Troybuilt pony riding mower 1 year old Could be anything. An air leak between carb and motor, wrong ...
...set. Besides the jets needing to be set, the needle may need to be reset also. If the dia. was alittle stiff than its going to need a new kit in it. 2 cycle carbs are alittle more finiky than 4 cycle ...
What are the carb. jet settings for the Mantis tiller? When the engine and carb were new, the factory settings were 1 1/4 turns out. As fuel deposits form and things wear, it is normal to need ...
...jets back in, you know to lightly seat them first and then turn them back out to their original position before you started.Note:The little spring inside of the carburetor goes under the float ...
7222m mantis tiller need a diagram or set up adjustment for the carburator Set low speed jet 1 turn out high speed 1 and a quarter turn out
Peterbilt clutch linkage diagram check the shematic for a concord jet maybe they have the same transmission set up?
492 questions posted
Usually answered in minutes!
52 Questions
5 Questions
2 Questions
