...the guide pins are close enough to hold the belt loose when not engaged, I have the same tiller I use now.tines cannot turn if belt is loose enough. Maybe you bought the wrong belts A verses V
...Frustrated adjust the travel on the rod that engages the tines,it sounds like its not getting locked into till position far enough and the vibration of the unit knocks it back out of till ...
Question about Honda Garden
...getting enough. there is a small screw on the side of the carb ( air mixture ) they are usualy ( from screwed right in ) 1 and a half turns out, try with 1 and a half turns out start engine and adust ...
...enough to adjust the HS jet. did that. Any suggestions? Steve Check fuel filter and lines, if thay are good I would get a carb kit and set the adjustment screws at 1 turn out from lightley seated to ...
...Enough To Engage It Into Reverse. It Also Pulles Hard The Cord Will Bind To The Point That It WillTip The Machine. If I Pull Till It Tightens UP And Stop Then Start Over It Will Start. Bought It New ...
...getting enough gas or there is a air leak. If I leave the choke on about half-way it runs smooth. I have cleaned the carburetor and there is plenty of fuel getting to the carb. I was wondering if the ...
...enough to get it started. Let the motor warm up a little then, with it idling, turn the low screw in until it starts having a hard time running then back it out until it idles smoothly. Prop up the ...
...getting the wheels and tines off. Any suggestions? there should be a cotter pin or pin holding a large washer once you have removed these then you have to get the wheel to slide off the axle it has a ...
cant get it close enough to start the tiller to adjust it... set low speed jet to 1 turn, highspeed jet 1and a quarter this should start ya off tweek from there.
...enough to get it back together. turn the spring in the direction that the rope would pull it out, until it won't go any more. Hold it, and reinsert the rope, tie a couple of good knots in the end, ...
492 questions posted
Usually answered in minutes!
52 Questions
5 Questions
2 Questions