1991 Chevrolet S-10 "bleed clutch" Questions

...clutch to bleed on 1996 s 10 we have bleed bleed and bleed Hi if you have done the following to bleed the clutch. 1 open bleed screw 2 push pedal to floor and keep on floor 3 do bleed screw up 4 lift ...

...on the slave cyl. Allow fluid to drip into an open can until there's no trace of air. Close bleed valve and try clutch. If still no pedal, repeat the process. This is quite an acceptable

...clutch slave cylinder. It does take a good couple hours to bleed one of these using the conventional two person method so it could still need bleeding but if it is taking to long and your initial ...

...clutch!?Can anyone help? I've been trying to bleed the cluthc for days.I can't get the air out.No pedal.Replaced the master cylinder. This is what I would do. Fill the master with brake fluid. Make ...

...bleed hydraulic clutch on this truck but am not sure of procedure. Where do I begin and how do I go about this. Thank !! well you will need some help make sure the resivor is full and have someone ...

...clutch 85 s10 blazer when I bleed the slave cylinder oil leaks out the bell housing First, unless you have just done some clutch work you should not need to be bleeding the clutch hydraulic ...

...bleed clutch on a 1989 S-15. The manual claims removing/ tilting the slave will remove air- but the short hard line used clued me to try another idea. I took a small windshield washer motor and ...

i replaced the slave cylinder on the clutch but cannot get it to bleed. to bleed have the engine off and press the clutch in 25 times

...clutch when i tried to bleed it according to the manual, (the clutch has already been replaced) this is happening more and more = pump the padel 100 times then bleed then maybe nesassry to pump 100 ...

...clutch fluid reservoir, make sure the bleed nipple on the slave cylinder is tightly closed. Now, with the piece of wood within reach, slowly depress the clutch pedal with your hand and hold it down ...