2000 Chevrolet S-10 "mesh computer" Questions

computer to lean out the mixture too far.have the air flow meter,located on the air intake hose tested by a gm dealer. it is a very delicate screen with 3 sensors across the very thin wire mesh ,so it

I have a 94 nissan pathfinder automatic. All of a sudden I have no reverse but the forward gears work fine Its needs the analyzer by computer, its possible that one mesh is damage or sensor is damage

...computer code Black paint with special NASCAR graphics on the box sides and tailgate Grey interior with NASCAR embroidery on the seat backs and floor mats Special mesh grill Goodyear A/S tires with ...

than me, but it will be toward the rear of the gearbox and usually has a small gear on the end that meshes with a mating gear on the output shaft as you put it in

...mesh on trottle to see gas poured in, if fuel injected there should be like a valve(like the one on the coolant line where one put freon in, press to see if pressure comes out. check spark to see if ...

...computer and traveled from NC to FL (1000 miles aprox). After that I drove in Florida about 300 miles and then the light went on again. What could be the problem?. You will need a new catalytic ...

...computer. I have known people that really got their t-cases messed up because they thought that shift on the go meant that they could shift the t-case into 4wd LO while moving but shift on the go is ...

...the horrible noise while starting, which is probably caused by the starter being worn, loose or not meshing correctly with the ring gear or perhaps the ring gear is damaged. These things can be ...

computer is located on passenger side on the right of glove box... will have to remove lower dash, glove box and one other panel to get to it... i assume you are looking for the ECU... the BCM is also

...with the starter. When you turn the key to start, a gear in the starter advances on a shaft, meshing with the flywheel, and then it cranks the engine over to start the vehicle. It sounds from ...