SOURCE: I have a 125 kaw kx 2 stroke good power on low end
Pull the slide out and then move the clip on the jet needle one notch lower. Also try two notches to see which helps most. This will richen the mix in mid-range.
Pleas rate thia answer. Thanks v222407! :)
SOURCE: Low-end Bog
tried this on the carb turn the mixture screw in a 1/4 of a turn
Testimonial: "I runnin 32:1 with ninety two octane gas"
SOURCE: 2001 kx 85 has sever low end hesitation. I can't
Hello you have a
1. fuel starvation problem clogged carburetor jets.(clean the carb)
2. Intake leak carb joint/intake manifold.( start your motor get it to idle best you can spray wd40 around the carb joint if the rpms change you have a leak replace the carb joint or gasket/o-ring as needed.
3. crankshaft main seal magneto side leaking or worn main bearing.
check end play on the magneto side remove the cover plate firmly grab the end of the shaft with up an down motion if you can feel it move replace the main bearings and seals.
These are problem that will cause your motor to run lean and hesitate.
Hope this helps you with your problem
SOURCE: low rpm boging,just did complete tune up replaced
How many miles? How's the compression? Could need rings. Running good fast/poorly slow is symptom.
SOURCE: If I'm low on coolant will the bike bog down and
She will loose power and possibly shut down if overheated. Check your cyclinder pressure. Make sure head didn't warp.
141 views
Usually answered in minutes!
×