How much oil do I put in my 2006 Kawasaki 250 KLX? @
Capacity:
1.3L (when filter is not removed)
1.4L (when filter is removed)
1.5L (when engine is completely dry)
Level:
Between upper and lower levels
SOURCE: FInd manufacture year by chassis number
The tenth character from the left is the manufacture year.
SOURCE: KLX 250 won't fire - new battery
-check the fuse right hand side below the fuel tank and seat, see if it is blown.
- Check to see if plug has spark, replace if necessary .
- Did you run the bike with a low battery before replacing it? could be that your stator is shot.
-Is bike trying to start but won't?
SOURCE: 2009 kawasaki klx 250 - need correct procedure for
•Using the jack under the frame, and stabilize the motorcycle.
Special Tools - Jack: 57001–1238
•Loosen the left and right axle clamp bolts •Unscrew the axle nut . •Place a stand under the engine to raise the front wheel
off the ground. •Remove the axle, and pull out the wheel. Take off the
collars and caps from each side of the front hub.
CAUTION
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so the disc does not
touch the ground.
•Insert a wood wedge between the disc brake pads this
prevents them from being moved out of their proper position,
should the brake lever be squeezed accidentally.
Front Wheel Installation •Apply grease to the seals. •Fit the projection on the cap to the groove on the collar. •Install the caps , collars on the left (longer collar)
and right (shorter collar ) side of the hub. •Insert the axle from right side. •Unbolt the right and left axle clamp bolts temporally. •Tighten the axle nuts •Tighten the left axle clamp bolts.
Torque - Front Axle: 78 N·m (8.0 kgf·m, 58 ft·lb)
Left Axle Clamp Bolts: 20 N·m (2.0 kgf·m, 14.5
ft·lb)
NOTE
○Tighten the two clamp bolts alternately two times to ensure
even tightening torque.
SOURCE: would the fairing parts of a 2006 kawasaki ninja
Yes I do believe they do. Try going to Powersportseast.com Look in the shopping section on the left of the homepage. You will want to use the parts fische and load the info for your bike. It allows you to see what the dealer parts counter can see. See if this helps. I'm pretty sure the 250 ninja really didn't change until 2008 when it got the BIG overhaul
Testimonial: "Thanks Fixya"
364 views
Usually answered in minutes!
×