20 Most Recent
2010 Sym Mio 50 Questions & Answers
How to make a mio 50 go faster
You need to check its restrictions ie carb stop exhaust restriction etc, then you can go for a sport variator /roller kit, available on line.
I need to kickstart my
It sounds to me as though the kick start quadrant is jammed in the transmission cover,remove it and check
HOW TO CHANGE REGULATOR ON SYM 300
To change the regulator on a SYM 300, you will need to follow these steps:
- Turn off the engine and remove the key from the ignition.
- Locate the regulator, which is typically located near the battery. It will be a small box with wires coming out of it.
- Disconnect the negative battery cable to prevent electrical shock or damage.
- Unplug the wires from the regulator. There may be a plastic clip or tab that needs to be released to remove the connector.
- Remove any screws or bolts that are holding the regulator in place.
- Carefully remove the old regulator and discard it.
- Install the new regulator in the same position as the old one. Make sure it is securely in place.
- Reattach any screws or bolts that were removed and tighten them securely.
- Plug in the wires to the new regulator. Make sure they are connected correctly and securely.
- Reconnect the negative battery cable.
- Turn on the engine and test the new regulator to make sure it is functioning properly.
It is important to follow the manufacturer's instructions and safety guidelines when working on any vehicle. If you are not comfortable working on your SYM 300, it is recommended that you seek professional assistance.
Not finding what you are looking for?