The resistor is located on the left front bumper support.To access the resistor on Chevrolet and Pontiac models, loosen the left front corner of the plastic wheel well liner where it attaches to the front fascia. Saturn vehicles do not require you to remove the front wheel or wheel well liner.
SOURCE: malibu air bag module location
The module is under the passenger side seat,under the carpet.You will have to remove the seat to access it easier.Lift up the carpet and it will be mounted to the floor.
SOURCE: location of the Heat resistor in a 2003 Chevy Malibu?
Under the glove box, behind the blower motor itself. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.
SOURCE: Trying to replace thermostat in a 2003 Chevy
The v6 engines has the thermostat mounted behind the exhast manifold on the engine to trans side
SOURCE: location of drl module 2001 chevy s10
The drl module is part of the body control module,(bcm) located under the dash on the heater box. The drl relay is in one of 2 places. In the
fuse/relay block on the left fender. Or taped to the body harness near
the hose for the rear washer. The rear washer hose comes out of the
bottom of the front washer bucket to the firewall. Hope this helps.
722 views
Usually answered in minutes!
×