-
Expert
327 Answers
- Posted on Aug 25, 2010
Re: How do I change a blower motor in a chrysler Town and...
Hello, to change the blower motor resistor follow this steps:
- Disconnect and isolate the battery negative cable.
- Open the glove box.
- Flex both sides of the glove box bin inward near
the top far enough for the rubber glove box stop bumpers to clear the
sides of the glove box opening, then roll the glove box downward.
- Reach through the glove box opening to access
and disconnect the instrument panel wire harness connector for the
blower motor resistor from the resistor connector receptacle.Blower motor Resistor
- Reach through the glove box opening to access and
disconnect the blower motor pigtail wire connector from the resistor
connector receptacle.
- Remove the two screws that secure the blower motor resistor to the evaporator housing.
- Remove the blower motor resistor from the evaporator housing.
Thanks
×