Brake lights stay on even with key off and the only way to get them to go off is to take battery cable off what could be the problem it's a 1995 Camry

there is wires that go to the brake can where u put brake fluid at check to see if low or disconnet the wires and see if light gos off

See if the rubber gaskets are at the top of the brake pedal. If you see two wholes, then they are not there. You might have to go to the dealler for those parts. I used a carriage bolt on the brake switch side for now with ducktape.

the fact that you have lights means your fuse is good-lights all the time means your brake switch (located above the brake petal) is hung up or stuck. You need to get down low enough to see it, under the dash and immediately above the brake petal-as you push the petal with your hand, you will see it attached to the brake linkage-for some reason, it is always 'closed' which causes the lights to stay on, even with the key off (safety reasons, this circuit is always hot). you should be able to 'unstick' it by manipulating it, or you can spray a light coating of wd40 on the assembly to sree it up. Worst case, you will need to replace it, the usually run under $20.

Brake Light Switch REMOVAL & INSTALLATION

1. Disconnect the negative battery cable.
2. Disable the SIR system (if equipped).
3. Remove the clip (R/V Series) or unclip the switch (C/K Series) and unplug the electrical connector from the brake light switch.
4. Remove the switch.
5. Installation is the reverse of removal.

Check the brake light switch, located under the dash above the brake pedal. The other noise may not even be related to brake lights staying on

You could have faulty altenator or short causing the battery to drain. The engine light usually comes on when anything electrical or sensor wise is faulty. Brake light will come on if, low brake fluid, e-brake handle is up.

Unplug the ECM connection and see if those lights go off.For some reason the relays are not turning off and are controlled via the ECM.

brake light switch malfunction.check on pedal

check the brake light switch on the pedal

Hi try disconecting the negative battery cable for two minutes and reconect it again,