SOURCE: how to change the battery in an 04 PT Cruiser.
for the 2.4L LE and BE PT Cruisers, the first thing you need to do is remove the air filter housing by un-clipping it. the tricky part is that the battery is held down by a clamp that requires you to remove the main electrical box and base. it looks harder than it is because it is simply two rubber grommets anchored to a metal plate. you can reach your hand underneath and feel for them, then push them upward through the anchor holes to release the base. you will see the clamp that holds the battery in place, just remove the two bolts that are holding it down and replace the battery with a new on and reverse the procedure. hope this was helpful, i spent almost 1.5 hours figuring it out
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: 2004 chrysler pt cruiser starter motor removal
You may sneak it out with small fingers with out pulling out the starter.
If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.
Please rate this a fixya
SOURCE: how do i remove rear power window switch, and
REAR - SEDAN ONLY
SOURCE: '05 PT Cruiser O2 sensor problems.
I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.
1,509 views
Usually answered in minutes!
Lips,
That is just crazy. I figured it out this morning and all you do is take off the air cleaner box and you get right to it. No need to take off the tire at least for a 2005 PT Cruiser!
×