'00 Pontiac Montana Drivers side power window, have established motor has failed. Window in full open position. Any way to get closed until repair? Over ride? Manual process
You would have to remove door panel and remove the two nuts fastening the window to the window motor regulator then slide window up and use tape to hold it up until you can get it repaired
What if the power window is held in with a scissor lift. I am having this problem. I want to just lift the window and I can not figure out how to get the scissor lift off.
Try pouring alcahol down the switch and let dry. My window wouldn't go up but went down fine. I took my trickle battery charger for my motorcycle and used it to send a charge to the the motor inside the door panel, bypassing the switch. This did get the window up until I could replace the master switch. If the window goes up, your motor is fine. If you reverse the charger wires to the motor, this will power the window down. Hope this is helpful !
You have to remove motor and a few bolts. It is a pain because you may have rivits going through the motor and those have to be drilled out, then you have to slide regulator(sicssors) through the side opening. If you just want to get the window up, look at previous post. If you cant get window to power up or down, using this method, you need a motor. Easy to replace.
×
894 views
Usually answered in minutes!
×