At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
How do you know it's the
seat memory
module ? It is located on the bottom of the driver seat .
Memory Seat Control Module Replacement
Raise the seat to the full upright position.
Unsnap the front track cover from the seat by sliding forward.
Remove the 2 front screws from the memory seat module bracket.
Remove the front seat anchor bolts from the rear of the seat tracks.
Raise and support the rear of the seat assembly.
Disconnect the electrical connector.
Remove the 2 rear fasteners from the bracket.
Remove the memory seat module (1) and the bracket.
1-Remove the bolts from the center of the hub,
2-now pull the axle
3-remove brake calipar and mounting bracket
4-remove hub nut(this requirs a special socket)
5-now you can pull the hub and rotor
Remove 2/3 of the brake fluid from the master cylinder.
Remove or disconnect the following:
Wheel
Caliper. Suspend the caliper from the frame with mechanic's wire. Do not allow the caliper to hang from the brake hose.
Caliper mounting bracket bolts
Caliper mounting bracket from the steering knuckle assembly
Brake pads from the caliper mounting bracket
Clips from the inside ends of the caliper mounting bracket and discard
To install:
Install or connect the following:
Clips to the inside ends of the caliper mounting bracket
Brake pads to the caliper mounting bracket
Inner pad (1 wear indicator)
Outer pad (2 wear indicators)
Caliper mounting bracket to the steering knuckle assembly
Perform the following procedure before installing the caliper mounting bracket bolts:
Remove all traces of the original adhesive patch.
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
Apply red Loctite®272 to the threads of the bolt.
Install or connect the following:
Caliper mounting bracket bolts to the steering knuckle. Tighten the caliper guide pin bolts to 74 ft. lbs. (100 Nm) on 15 series or 80 ft. lbs. (108 Nm) on 25/35 series.
Caliper
Tire and wheel assembly
Refill the master cylinder to the proper level with fresh brake fluid. Pump the brake pedal slowly and firmly in order to seat the brake pads. Burnish the brakes as needed.
Yes, but if you don't have a really good diagram for both, you will need to identify each function by trial & error, then remove wires in harness and put them in the right places in the harness plug Use original plug from old seat on new seat.Don't change anything in body harness.
×