Edu - what's that ? explain .
Door Lock System Controls
The power door lock system is controlled by the BCM and can be activated by any one of the following:
• A door lock switch Lock or Unlock actuation
• A door lock cylinder switch Lock or Unlock actuation
• A keyless entry transmitter actuation
• An automatic door lock actuation, a Personalization function
• An automatic door unlock actuation, a Personalization function
• A last door closed locking actuation, a Personalization function
Door Lock Operation
When the BCM detects a transition of either of the door lock switches to the Lock position, it switches the door lock actuator lock control circuit to voltage. Since the lock actuator unlock control circuits are at ground potential within the BCM, the door lock actuator motors transition to the Lock position.
https://www.youtube.com/watch?v=klFhJHoV...
Having the BCM checked for DTC'S - diagnostic trouble codes could shed some light on the problem .
×
SOURCE: Thermostat in a 2003 chevy venture van
the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down
SOURCE: Thermostat in a 2003 chevy venture van
no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.
SOURCE: Radio, Key auto door lock/opener, interior lights not working.
Most likely is a fuse. There is a fuse box at the end of the right side of the dash. Open front passenger door and there is a cover that says fuses on the end of dash. There is also a fuse box located under the hood at the right front of engine compartment. It should have a cover with a round knob in the middle of it .Unscrew the knob to remove cover.
SOURCE: how do you reset power sliding door on 2000 chevy venture
there should be information in your owner manual telling you how to do it if you have miss place your owner manual try this website to see if you can down load one for your car its www.edmunds.com and i hope i was able to help you Michigan Man
SOURCE: 2000 Chevy Venture shows gas gauge as always full..
if the remote works but the switches inside the van doesn't then the most likely fix would be the switch, tthough it is strange that both would quit. the place too start would be pop out the switch with a small screwdriver and disconnect the connector. the top left pin and the top middle pin is the unlock circuit in the switch. check continuity with your multimeter while pressing unlock. if no continuity, then get a small piece of wire and jump those pins in the connector,( the top right and center ) you should hear the doors unlock, then you know for a fact that the switch is bad. the unlock is used more than the lock so it is a more common failure. you can also use a continuity test on the rear wiper switch. though it is more common that the motor would stick from not being used. hope this helps if you have any more questions i am glad to help... dustang
79 views
Usually answered in minutes!
×