Push down on accelerator pedal 3 times within 5 sec to the floor
Turn key to ON/RUN with engine off
Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalize menu.
Press the information button to scroll through the available menu modes until the DIC display shows "OIL-LIFE RESET
Press and hold the reset button until the DIC display shows "ACKNOWLEDGED".
Turn the key to "LOCK/OFF".
SOURCE: reset change oil display 2008 jeep
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three
times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
SOURCE: Oil Life Reset
Put the key in the ignition, and turn it on (don't crank the engine) while holding out on the small instrument cluster stalk near the clock. When the key is turned on, keep holding this stalk out, and push and release the other one (the one on the right). This should turn the "oil service" message to "----". Turn off the key and then release the left stalk. When you turn the car back on, the message should be gone.
SOURCE: Need to reset the oil change indicator, changed oil myself
press and release the setup button to display oil life= xxx
then press and hold the reset button for about 2 sec it should then display oil life set to 100%
SOURCE: resetting my oil life on an HHR
Turn key to "on" position. Fully depress and release gas pedal 3 within 5 seconds. Turn key off. Should be reset now.
SOURCE: HOW TO RESET OIL LIFE MONITORS ON 2008 CHEVY
Equinox 2005-onwards
Turn ignition to the "ON" position. Slowly depress accelerator pedal 3 times
within 5 seconds. "CHANGE OIL SOON" lamp will flash. Turn ignition off.
122 views
Usually answered in minutes!
×