SOURCE: replaced thermostat and flushed out heater core 3
If the heater core is not damaged or leaking ie: if you don't see coolant on the INSIDE of your windshield or coolant on the floor inside the car then chances are you may just need to BLEED the radiator.
remove radiator cap
Fill coolant resovoir to the cold line if the engine is cold from sitting overnight.
Start engine with cap off
Wait till engine gets hot
While waiting you will see a big gurgle of air bubbles come out and the coolant level will drop
Fill the radiator with more coolant to compensate.
When the fans come on and it stops gurgling air install the radiator cap
You are done
Watch the coolant level for the next few days and top off in the resovoir as needed to keep it filled.
Your heat should be very hot now providing you installed the correct oem thermostat correctly.
Hope this helps
SOURCE: heater problems 2009 dodge nitro v6.
Possible, with rad cap off, let vehicle idle until coolant fan comes on then shut vehicle off for 30 minute cool down. Top up rad, install cap and drive and recheck heater operation and any overheating.
111 views
Usually answered in minutes!
×