Question about Cars & Trucks
Take it back the the transmission shop, it needs to be further diagnosed and probably rebuilt.
Posted on Oct 17, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
see my comments, not 100% sure that it was the out put speed censor or not, but after reconnecting the wires to a new censor and reconnecting the battery and clearing codes it worked. connection was not clipped may have been loose
Posted on Oct 07, 2008
Your trans is going into limp mode and that is why it is starting out in a higher gear.With the o/d light flashing there is a problem.Try this disconnect the battery for 5 min then start the car,before you do anything cycle the o/d button and see if it starts flashing.If it does then there is somekind of electrical problem.Could be bad wire or bad solenoid.If not drive it and start out with o/d off in low and shift manually through the gears and see if they are all there when you need to get in fourth hit the o/d button to shift and see if it does.They should also be able to get a code for the flashihg light to try to pin point.Hope this helps and thank for using fixya
Posted on Nov 30, 2008
Sir I would first change my filter. When you do you should be able to acertain if anything is wrong by what yuo find in your pan. I think your clutchs are probably bad, but with out being able to scan it I don't have any other ideas. I have been lucky a couple of time before and changing the filter solved my problem. Your car is in limp mode generally you have reverse and second gear. 1st gear and reverse use the same clutches, so I am wondering if maybe you have second gear only!
Posted on Dec 26, 2008
SOURCE: bmw 325i 2003 stall
Sounds like you have a small bit of dirt or grit in the fuel system when accelerating it is drawn with enough force to cut off the fuel supply then is released when engine at Idle.
1 run liquid fuel line/injector cleaner in 1 tank
2 check fuel lines for debris
3 change fuel filters
4 have fuel tank flushed
here is trouble shooting order less expense to greater.
Posted on Aug 23, 2009
Tips for a great answer:
Dec 06, 2012 | 2006 Chevrolet Cobalt
Oct 10, 2012 | 2006 Chevrolet Cobalt
Aug 18, 2012 | 2006 Chevrolet Cobalt
May 28, 2012 | 2006 Chevrolet Cobalt LTZ
Oct 25, 2011 | 2006 Chevrolet Cobalt
Sep 15, 2009 | 2006 Chevrolet Cobalt
Aug 05, 2009 | 2006 Chevrolet Cobalt
May 05, 2009 | 2006 Chevrolet Malibu
16 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: