Question about Chrysler Cars & Trucks

Open Question

2008 chrysler aspen display console

Display console has completely quit working. No radio, navigation, phone...This began on a road trip, started going in & out then eventually quit working at all.

Posted by on


6 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017



  • 10 Answers

SOURCE: Car display console suddenly stop working

there is a module that controls that called the CCC- Car Communication Computer. My guess is that was damaged from the accident. hav a dealer check to be sure. Module is VERY expensive, so may wanna think about going through insurance for this

Posted on Feb 13, 2009



  • 2 Answers

SOURCE: Radio display does not work

Honda has a problem with the PCB board in the radio, See your Honda dealer for repair info. Service bulletin 04-027 says:

"In some audio units, a component failure on the PCB
(printed circuit board) could cause the audio display to
become dark or dim, and prevent the audio/HVAC
panel buttons from illuminating.
To ensure that customers have adequate warranty
coverage for this potential problem, American Honda is
increasing the warranty on the audio unit display to
7 years or 100,000 miles, whichever occurs first. For
other defects the standard 3 years or 36,000 miles
warranty applies, whichever occurs first."

Posted on Feb 15, 2009


  • 1 Answer

SOURCE: Center Console Display Not Working

Changed the battery yesturday in my Mazda rx-8. Now my radio/CD and my A/C won't work! It's all black! Wot to do???

Posted on Jul 01, 2009


  • 155 Answers

SOURCE: 2005 chrysler 300c... radio display

get used to it or a used radio from a junk yard

Posted on Feb 24, 2011

Adam Scott Roberts

  • 1243 Answers

SOURCE: chrysler dodge 600 radio display and radio itself not working! Don't want to replace unless its exactly the same.

bad quartz display. may can find a replacement at a salvage yard.

Posted on May 31, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the air idle control on the 2008 Chrysler aspen?

They did away with them when they started using the drive by wire system. Electronic throttle.

Apr 13, 2016 | 2008 Chrysler Aspen

1 Answer

2008 chrysler aspen shut down completely in drive and won't start. Starter engages but won't start starter wire also gets very hot.

Engine froze up or not able to turn with the starter that is drawing alot of current to try to turn the motor

Dec 27, 2015 | Chrysler Cars & Trucks

1 Answer

2008 chrysler aspen radio on and off randomly any one no why are shorts common

It is not a short circuit. That would blow a fuse. There may be a problem with the on/off power button on the radio itself.

Mar 26, 2015 | 2008 Chrysler Aspen

1 Answer

Dvd screen stopped working on my 2008 chrysler aspen

That happens when the dvd is bumped from bad roads so not much you can do but repair or replace.

Oct 27, 2013 | 2009 Chrysler Aspen

1 Answer

Just had transmission serviced and 3 days later it just all of a sudden quit working ?

That is what happens when you fail to change transmission
fluid every 3 years,then believe doing so, is a fix

It will slip worse, as you found out

You should have been asked a lot of questions &
the car road tested or the fluid should not have
been changed

You went to the wrong place & now may have a
major repair to do

Sep 12, 2013 | 2008 Chrysler Aspen

1 Answer

The radio in our 2008 Aspen is not working at all. The fuse is ok. Is there a way to reset the radio?

Hello, Besides the fuse in the car fuse box, behind the radio you should have another fuse that goes into the power line of the radio "most radio's do" . Tho some don't. That may be what has blown that is keeping it from turning on. I would suggest removing the unit from your dash and check the fuse behind there. Hope that helps ya.

Jan 02, 2011 | 2008 Chrysler Aspen

5 Answers

Reset oil maintenance light in 2008 toyota highlander

  1. Set the "ENGINE START STOP" or engine switch OFF with the trip meter A reading shown.
  2. While pressing the trip meter reset button, set the "ENGINE START STOP" switch or engine switch ON.
Without multi-information display

  1. Continue to press and hold the button until the trip meter displays 000000.
With multi-information display

  1. Continue to press and hold the button until "COMPLETE" appears on the multi-information display.
there you go jimmy mark as fixya

Sep 26, 2008 | 2008 Toyota Highlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides