All of my tires are at the proper psi but light won't go off
It could be one of your TPMS sensors are not working properly or battery is dead in the sensor I was thinking they reset once the pressure is in the right range you might have to drive it a few miles to reset
What kind of vehicle? Make, model, year? All are different.
SOURCE: LOW TIRE PRESSURE WARNING LIGHT
Turn ignition to run position,go to fuse panel right hand of vehicle,push and hold reset button for 5 seconds,low pressure light will flash 3 times,start car it should turn off the low pressure light.
SOURCE: low tire pressure light is on all tire pressure is
Turn off the radio and turn the key to the on postion. push the bottom knob ( to turn the station). Hold it in intell the info comes on. in the window it will show all the things you can reset. using the arrows to the right of the knob find tire reset the push on the station knob. this will reset it. then go back to the arrows and find end. push on the knob one more time and you will be done.( you have to make sure the radio is off). I hope this helps.
SOURCE: Tire pressure light is on
You cannot reset them,Make sure that you check the pressures in the tires. The Infiniti Tire Pressure Monitoring System is designed to trip the warning light anytime the pressure in any of the tires drops below 29 psi. At 29 psi it really won't look like the tires are low. You could have one tire at 29 or 28 causing the light to stay on all the time. Check your pressures, set at 34 or 35 to be safe, or whatever pressure the tire is recommended to be. Not all infiniti vehicles with TPMS have the display that shows the pressure in each tire. If the pressures are above 29 psi, Then there could be an issue with one or more of the sensors. If you have the tires replaced you will have to have the sensors relearned at the dealer. Tire rotations do not require the same.
SOURCE: location of tire pressure reset button on 06 cls500?
How do you reset the tire pressure on a CLS 500?
SOURCE: how do i reset low tire pressure light after
This normally will do it by itself sometimes you have to use a tool for tire sensor but I would make them all the correct pressure by the sticker on drivers side door and drive it then it should register it if not You will need to have a tire shop run the tool on it probably only 10 bucks to have done
40 views
Usually answered in minutes!
×