Was key and ignition module flashed to your vehicle
If you changed the switch you will have to go to the dealer and get the key coded. Ignition keys are coded to the specific computer and the key has to come from the dealer who knows the codes. This is what I had to do on my Camero. If this does not help call your Chevy dealer and ask them if they can code the right key.
SOURCE: installing ignition switch for 87 chevy s10 Blazer 2.8L 4X4
you need to replace the electrical part of switch?If os it is down on column under dash will be two bolts holding on with the dimmer switch also
SOURCE: Short in steering column wiring
torque bit 20 to remove the air bag bolt in the back cover stering puller stering puller to push plate phillip screw driver that about it pierre
SOURCE: 2001 Mazda tribute key does not start the car
??start??have you put the chip out of the old key into the new key??
SOURCE: replace a steering column on 1989 chevy k5 blazer
The best thing to do is to buy a Chilton,s repair manual. It has step by step procedures. You can get one at most auto parts stores. They coast anywhere from $10-$30 dollars.
SOURCE: Replacement of Water Pump. 2001 Chevy Cavalier 2.4 L
Stick with me on this
1.Put the car on jack stands
2.Remove the exhuast manifold, Do not rotate the flex cuopling more then 4 degrees od damage will occur.
3.Diconnect the coolant inlet pipe from the water pump outlet hose, Disconnect from the engine, disconnect it from the thermostate housing and remove it.
4.lower the car back down of the jack stands.
5.Detach the brack booster hose.
6.Remove the timing chain cover and the tensioner.
7.Remove the heater outletpiper from the water pump.
8.Remove the water pump cover bolts.
9.Remove the water pump retianer nuts.
Remove the old gasket and clean.
10.On bench. Install the waterpump and cover but lreave the bolts finger tight.
11.Install back in car, leave water pump bolts looseto allow for positioning.
12.Install water pump cover to engine, tighten by hand.
13.Lubricate oringand install metal outlet pipe back into pump, hand tighten.
14a.Tighten the water pump to timing chain nuts
14b.Tighten the water pump cover to water pump housing bolts.
14c.Tighten water pump cover to engine block bolts.
14d.Tighten the radiator outlet pipe to water pump.
15.Install timing chain tensioner.
16.Install exhuast manifold.
17.Install exhuast pipe.
18. Fill it up and bleed the system.
Good luck
147 views
Usually answered in minutes!
×