At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
do you have intake manifold bolt sequence for 3.8l 232ci 1993 mercury cougardo you have intake manifold bolt sequence for 3.8l 232ci 1993 mercury cougar
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Use a skin coat of RTV silicone on both sides of the water passage ports (outer most holes) and put the new lower intake gaskets into place
Hand tighten the 13mm head intake bolts and Torque the bolts , starting from the center and working your way out in a circular pattern
Torque these bolts in a few small increments until they have reached 250 inch pounds of torque.
Upper Intake Plenum:
When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be torqued to 250 inch pounds .The fuel rail bolts should be torqued to 100 inch pounds
www.fordforumsonline.com > Ford Tech Forums > Engine & Drivetrain
May 7, 2010 - 2 posts - 2 authors
ISO torque specs for the intake & plenum for a 98 Windstar...3.8 with the ... Our community is here to help you with any questions you have related to your Ford. ... Lower Intake Manifold to Cylinder Head Bolt 8-12 - (71-106).
(step 1 ) the torque specs for the heads are---1998 through 2001 are 37 foot lbs. ( step 2) rotate an additional 90-degrees (1/4 turn). intake manifold bolts ( lower ) step 1-- 62 in-lbs, step 2--115 in-lbs. intake manifold bolts/studs ( upper ) 18 ft-lbs. this is for the 3.1 v-6, have a good day!
Step: 1 - Torque to 25 ft/lbs Steps: 2 - Torque to 50
ft/lbs Steps: 3 - Torque to 50 ft/lbs Steps: 4 - Turn 90 degreesRecheck
final torque in sequence
Caution:Engine uses torque to yield head bolts
(TTY) that permanently stretch during initial installation. New head bolts
must be used when cylinder headis replaced or re installed to obtain
proper torque specification.
need torque spec for flywheel to crankshaft on 2000 dodge caravan 3.0 v6
Head bolt torque spec for v6 nm pajero
head bolt torque sequence and specifications, slant 6
×