Can you remove the hold down bolts or nuts that hold the seat to the floor, then move the whole seat to get a look behind the seat? I'd have to look to see if there is access to the trunk, behind the seat. Just a thought.
In the past I have had locks, where I broke the key off in the lock, not automotive. I drilled out the key cylinder to get it open. I don't want to cause more problems than you already have? If you drill out the key cylinder, I don't know if the trunk will open? If so, then maybe you could replace key cylinder after you fix everything. You could call locksmith, see if they can get it open? Don't try anything if your not comfortable with the procedure. good luck.
SOURCE: where is the release for the backseat to fold down
If your trunk release button is electric, and not working because you need to turn the key to give it power, remove the button and use a piece of wire to jump power to it from the battery. This will get your trunk open! (don't forget to have a spare key made)
SOURCE: trunk lide wont open
Try to apply pressure from the top of the trunk and push short burst while using the key, If this doese not work you can try to enter from the rear seat taking out the bolts for the rear back rest.
SOURCE: trunk release and fuel door release buttons do not work
i just bot mazda millenia and i can't find trunk release???!!!!
SOURCE: Trunk latch pull down
You could try setting release to work manually. I have had the same problem. Take tne motor off set the catch clip at the right height. This should work with no cost.
SOURCE: I have an 06 impala and the TRUNK WON'T OPEN. It
you have a fuse for it ,check the fuse box ,it might not say trunk on fuse panel, you might need to pull those fuses out one by one checking each one to see if blown, if the center between the two sides are broke the fuse is blown, hope this helps you, thanks robert b.
300 views
Usually answered in minutes!
×