Need a wiring diagram for a bosch alternator

everything alternators put out power not receiving

usually generator or alternator. what is the wiring diagram for?

If you need further help, reach me via phone at https://www.6ya.com/expert/ray_6d6dc1dfa6f18dc1

Hope this helps...Alternator Wiring Diagram

The wiring for alternators depend on the make. The Bosch and Lucas are the easiest. Ducelier not bad. Mitsubishi you have to be in the know, etc etc. What type do you want to install.

https://s11.postimg.org/crrcun103/generator.jpg

Click on the link.
The diagram shows generator with internal voltage regulator and with external voltage regulator, at the moment, I don't know which one you have?
The bat terminal at the generator should be hot even with the key off, is it, use a test light. If no voltage either the fusible link is faulty or the wiring circuit to battery +. You can see fusible links in diagram.
Could be other issues, the generator probably needs excite voltage or it won't work. The excite voltage comes from charge indicator circuit. Does the charge lamp on the dash work?

Here's a diagram of an 1.9L engine DOHC and SOHC, generator is where the alternator is located, hope this was very helpful.

This is from the workshop manual, direct quote.

Generator, Aerostar
Removal
1. Disconnect battery ground cable (14301).
2. Remove snow/ice shield.
3. Remove engine air cleaner intake tube (9A624).
4. Disconnect generator wiring at the voltage regulator (VR) (10316).
5. Remove attaching nut and wire from generator (GEN) (10346) output terminal.
6. Remove wiring connector bracket.
7. Loosen the drive belt tensioner (6B209) and remove the drive belt (8620).
8. Remove generator brace (10B315) and bolt attaching generator to drive belt tensioner bracket.
9. Remove generator from the generator mounting bracket (10153).
Installation
1. Position generator on the generator mounting bracket.
2. Install the attaching bolts and tighten to 40-54 Nm (30-40 lb-ft).
3. Install the drive belt over generator pulley (10344).
4. Adjust the drive belt tensioner as outlined in Section 03-05.
5. Install wiring terminal and attaching nut on generator output terminal.
6. Install wiring connector bracket.
7. Install engine air cleaner intake tube.
8. Install snow/ice shield.

Connector Cavity B has the red wire and Connector cavity C has the Gray wire in it.

Looking at the end of the connector that plugs into the generator, going left to right... Cavity A,B,C, and D.

new generator? there is only alternator, wiring harness for whole vehicle or to alternator, parts store has alternator around $200 for part, regulator is manual or power and u install or mechanic?

what to do first is remove the regulator then un tape loom of regulator wires some of the wire go to the old generator remove the ones linked

now there should be one wire that goes back to the engine loom that was going to the reg or gen

now with someone helping get them in the car turn on the ignition on the gen light should be on yeah
now u place wire on + side of battery and ask if light go out if it does then u got it


THE ONLY PROBLEM IS NEED MORE DETAILS ON WHAT BRAND ALTERNATOR FOR WHERE TO PUT IT

RATE MY HELP MATE TELL ME HOW U GOING WITH IT