SOURCE: Nissan Frontier torsion bar replacement
well it depends how you want to adjust it, if you want to lower it, back out the screw on the torsion key a couple of turns. raise, screw it in a couple of turns
SOURCE: want to change torsion bar keys
The torsion keys are supposed to give 2-3" additional drop vs.the "free" method. I know adjusting the torsion bars kills the ride but how bad is it and how far can you go???
Believe, 15/16 socket would be the correct size. Also, be aware that they are probably pretty rusted and VERY hard to turn at first. Air tools do no good, so you'll need a 1/2" drive breaker bar and a long pole to put on the end. This is the fastest way to get the torque you need to break those suckers loose.
I suggest measure and writing down the height about 3-5 spots on each side, whether it be the frame, body, or whatever. Crank each side a few FULL thread turns, then measure again. Once you get about the height you want, measure both side to make sure they're equal. After that, it's best to get a full alignment as some of the suspension will now be at different angles (of course).
SOURCE: 95 explorer lower control arm replace
No the torsion bar if you look at it where it goes to the under carriage it will have a bolt for tension on each side. Are you tring to replace the bushings for the torsion bar? If so answer back.
SOURCE: how do i adjust the torsion bars
losen the nuts on the crank located towards the rear ,remove top nut and tighten the lower nut untill desisered hight is obtain
SOURCE: Adjusting torsion bars landcruiser 100 series
when you get a front end alignment that adjustment is made for you also. Do not attempt to do it for you will not get the adjustments correctly done without the specifications that are needed
1,011 views
Usually answered in minutes!
Also my o4 Tahoe has been dropped quite a bit I do believe it was done properly but my concern is looking down them on the left and right side the part going into the steering control arms one side looks like it is pushed into the steering ctrl a lot farther than the other side should they be evenlly spaced attachING to the strg ctrl?
×