Door sensor for what ? Door ajar light lit on the instrument cluster ?
Testimonial: "The sensor is for door ajar and window up and down"
Which door are you talking about ? front door ,passenger door , rear lift gate ? Front doors an passenger doors have a door ajar switch ,same switch which turns on the lights when the door is opened . An there is no sensor for window up an down .
Driver's side rear door door ajar stays on window doesn't work and can't set alarm
Door ajar switch wouldn't cause window not to work . Viewing wiring diagrams an using a DVOM - digital volt ohmmeter is how to find the problem . View wiring diagram to see what all is involved in making those systems work an then test . https://www.youtube.com/watch?v=4EW3aLRz...
watch a few repair videos on you tube .Buy repair info. service manual fromhttp://alldatadiy.com/?affiliate_id=9377...
Watch training videos for electrical testing
https://www.youtube.com/watch?v=SO-eKuhC...
Don't guess an don't expect someone who hasn't looked at or tested it to give a magical fix . Training an more training an more training is how i learned how to trouble shoot electrical problems .
×
It. Is in the slot where the door catch to the car body but in the door is self
SOURCE: 2006 CHEV SILERADO 5.3LT 4 DOOR 4W DRIVE DRIVER DOOR SENSOR
It is likely that you have a loose connection at the sensor somewhere between the sensor and the computer. Start by checking the terminations at the door sensor, and if they are tight, use a ohmeter and check the contact resistance for the switch in both open and closed positions. It could be that the switch is shot.
SOURCE: How do I replace the rear window panel ( Drivers
should be a couple of screws and maybe bolts behind door trim and inside body mouldings
SOURCE: where is the fuse located
From owners manual...
...check position 3 for rear wiper. The instrument panel fuse block is located on the passenger's side of the center console, to the left of the glove box near the floor.
Hope helps.
SOURCE: what are the steps to
Hello and welcome to FixYa!
As a first course of action please browse the internet to know what does the 2007 chevy equinox egr valve looks like. The egr valve is secured by two bolts, please remove the egr valve connector (black) first before removing the bolt. After removal you're good to install the replacement part.
Hope this helps and thank you for using Fixya! Have a good one!
SOURCE: Where do I find instructions
It's not all that bad. I replaced mine with mostly normal tools (maybe torx bits). you have to pull the interior panel from the door to have access to it, and remove the wiper arm (probably the hardest part to get off). Just take your time and make sure you find all of the panel screws and don't drop things on your head.
2,710 views
Usually answered in minutes!
Driver's side rear door nothing is working no power window says door ajar on dash,
dome light stays on and can't set alarm
×