How to remove idler arm bushings on 1964 Chevy II

SOURCE: removing idler arms for a 1989 chevy astro van

are you try to remove the tapered end that connected to the steering linkage ? if you are you will need a pickle fork, some part stores will rent this tool to you good luck kdc744

SOURCE: replace idler arm/pitman arm

Don't worry it is not too hard if you keep at. One "special tool" that you will need is a ball joint separator to separate the ball joint on the idler arm from the steering. When changing make sure to compare your replacement parts with the original and if necessary make a diagram of how things go together. On the bottom, there is a castle nut and a cotter pin. Remove the pin and loosen the nut then use the ball joint separator to remove the idler arm. (This is the hardest part of the job.) Then remove the remaining bolts and take the part off. Before putting the new idler arm make sure that you put the new grease fitting on it (and go ahead and squirt a little grease in it even though it already has some) and in between the new ball joint and the steering there should be a plastic bearing that slips into place. It's a pretty straight forward job and once you take a good look at it you will see what all needs to be done. Hope this helps, let me know how it goes. Goodluck!

SOURCE: repair steering linkage

You'll have to rent or borrow a pickle fork and a pitman arm puller. There is more than one size of pickle fork so specify for tie rod ends. You can buy them too, about $100 for the pair and they are not vehicle specific.
Jack and block up your front end so the wheels are clear. Take the nut off the tie rod end and wedge the pickle fork between the tie rod and the drag link, rap with a hammer until it separates. Loosen the bolt on the collar and unscrew the tie rod end. Count the turns when you remove it and screw the new one in the same number of turns.Fit it into the drag link and tighten the collar and the new nut.
Take the nut off the idler arm and use the pickle fork to separate it from the drag link. Unbolt the idler arm from the frame. The new one goes on in the reverse.
You'll probably need an adjustable wrench to remove the nut from the pitman arm,it's bigger than most wrench sets. Separate it from the drag link first. Slide the puller on and tighten it up. Once it starts to turn hard, give the bolt on the puller a rap with the hammer and tighten some more. Repeat until the arm comes off. Slip the new one on and tighten.
Don't be shy when you tighten these parts because if there is play, the holes in the drag link will oval out and you will have to replace it too. Don,t use a pickle fork on the pitman arm or you will have to replace the seal in the bottom of the steering box. Hope this helps.

SOURCE: i need to replace my idler arm and pitman arm on

you will have to remove the steering gear box to change the pitman arm. the idler arm is on the other side by the passenger wheel. one nut and two bolts going threw fender take it off.

SOURCE: How to change the pittman arm and idler arm on a

Pitman arm requires a pitman arm puller, and a tie rod seperator or "pickle fork". Remove the cotter pin on from the joint on the pitman arm and center link, then remove the nuts from both ends of pitman arm. Use the pitman arm puller to remove the pitman arm from the steering gear, then use the tie rod seperator to remove the end from the center link. Reinstall and retighten nuts, do not leave out the cotter pin.
Idler arm will require tie rod seperator. Remove the cotter pin from the end at the center link, use the tie rod seperator to seperate the joint there. Unbolt the idler arm from the frame, and remove. On reinstalling remember to install a new cotter pin. It would be best to have the front end alignment checked after replacing these parts.