My toyota celica 2001 is heard to get in gears when changing,,any Ideas

SOURCE: 2001 Toyota Celica GTS Clutch

i paid a friend to do it because it's a lot of work! if you haven't already treid to or got it done just know that when my friend did it; it took him like 8 hours (he'd never done one on a celica, but had done them on american cars) so if your not familiar with it... not a good idea to do alone. I watched him do most, but i'm not the best to talk to about it.(plus i have a 2000GT) Some of the parts that i can remember that he took out to get to the clutch were the front driver's side tire, the axel on the same side, ....some other parts in there....and ALSO parts on top...the intake also had to be taken out just to have enough room to do the job. parts are cheap...just ask for a clutch kit at auto zone or whatever. around $150. another random tid bit that might help is make sure to tighten the engine mounts really good afterwards or else it will jump around in there when you turn it on and cut it off. buy gear oil before you start as well because you will need to put some in after the new clutch is in. i will need to put the car on a real lift... you need a lot of space underneath and on top to work. and most likely two people. well hope some of this helped.

SOURCE: toyota celica flat spot

had same problem,changed air flow meter sensor and problem gone.

SOURCE: My bottom gears won't work in my 1991 Toyota Celica ST 5 speed

sounds like synchronizer ring assbly

shack

SOURCE: 2001 toyota celica head sticks, possible oil pump.

Replacing the oil pump is a major job which involves tearing into the engine. I don't know what you mean that the cylinder head sticks, but I can assure you that just replacing the oil pump is not going to fix your problem.

Greg Bernett

• 2993 Answers
• Posted on Feb 27, 2010

SOURCE: How to instal serpentine belt Toyota celica 2001

Removal & Installation

1. Remove the right hand cover under the engine.
   
2. Turn the drive belt tensioner clockwise to relieve tension on the belt.
   
3. Remove the fan and generator V belt.
   
4. Return the tensioner to the unloaded position.
   
   NOTE When retracting the tensioner, turn it clockwise slowly in 3 sec. or more. Be sure not to apply force rapidly. After the tensioner is retracted all the way, do not apply force any more than necessary.
   
   

1. Turn the drive belt tensioner clockwise
   
2. Install the belt.
   
3. Install the right hand cover under the engine.