Question about Cars & Trucks

Open Question

How do I turn off front passenger airbag in a ldv maxus?

LDV 2008 maxus

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: ldv maxus wont start off key but goes with a push everytime

You could check your battery if its properly charged then check your alternator, probably d alternator is bad and doesnt charge the battery wel enough. So its either your alternator or ur battery. Also try removing a batt terminal after each drive to avoid draining

Posted on Jan 29, 2012

Ad
narlock_ald

Al Narlock

  • 81 Answers

SOURCE: 2007 ldv maxus 2.5 van will only start with easy stast and it comes up with 1 fault crank position sensor

next would be to check the fuel pressure at the fuel rail (under hood @ fuel inj sight) It sounds more like a fuel delivery problem then an electial problem

Posted on Jun 03, 2012

emissionwiz

Marvin

  • 85206 Answers

SOURCE: error code 0734,at my car LDV MAXUS 2,5! The motor no power

P0734 - Gear 4 Incorrect ratio
Possible causes- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit problems

Posted on Oct 25, 2012

marcca35

  • 21 Answers

SOURCE: Why does my ldv maxus loose power

have you had the codes read? may have clogged cat

Posted on Jan 28, 2015

Paula Hamilton

  • 847 Answers

SOURCE: 56 plate LDV Maxus, right hand indicator makes the rear fog lights flash along with the indicator

Hi,when this happens its normaly falty bulb or falty lamp holder which is creating bad earth,to find out if its a bulb swap all the bulbs at the back, so take the bulbs from left and put them in right and vicer vercer,if still blinking then take the board to have tested.
hope this was some help.

Posted on Apr 12, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reprogramming remote for ldv maxus have lost program how do i get it back


ignition on to all dash lights on before engine start, and press fob. 2 times doors should lock and then unlock. turn off ignition and press again 2 times then it's done

Mar 10, 2018 | Cars & Trucks

1 Answer

Help needed have a Ldv Maxus, put a new plastic grommet into clutch pedal today as the old one broke, now having trouble getting it into gear unless I pump the pedal Any Idears please.


Sounds like there is now air in the system. If there is a bleed nipple on the slave cylinder, bleed the clutch with new fluid. If not, it is a sealed system and both the master and slave must be replaced as a pair and ensure you follow the instructions otherwise you will get air in the system again.

Jun 01, 2017 | Cars & Trucks

1 Answer

Can i adjust idle speed on my LDV maxus 2008


should be between 600 and 750 . if it works now leave it alone .

Aug 05, 2016 | Cars & Trucks

1 Answer

How to fix 5th gear on my ldv maxus


Its likely you have a problem with the clutchnot completly disengageing or problems with disk or pressure plate

Jun 13, 2013 | 1997 Chevrolet Cargo Van

1 Answer

Error code 0734,at my car LDV MAXUS 2,5! The motor no power


P0734 - Gear 4 Incorrect ratio
Possible causes- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit problems

Oct 25, 2012 | Cars & Trucks

2 Answers

Help!!! how to reset a LDV Maxus key fob?


Hi
I know from experience that you cannot really re synch these fobs on the LDV Maxus vans.
What actually is the fault is an onboard component on the pcb has failed and we normally just replace that with a new one..the fob will be tested for operation and sent back. OR its the Relay in the ESA unit - under the left hand front glovebox on the bulkhead - black with cables going into it. We have those relays (soldered to the pcb) we can supply those or do the work for you. The fob connects to that ESA and the unit then fires the relays to open/close the doors. Sometimes that unit is installed upside down which causes water (condensation) to enter the box and have fun with your electrics.
The fob is SYNCHED to this unit via coding we can use your old fob to clone to a new fob and that will work with the ESA and the vehicle.
We have the parts on this link Items for sale from remobilise ltd

Here is a link to how to program the fob to the vehicle via the programmer - NOTE how you MUST have a working fob to program another (text at the start of the video... LDV Maxus flv

We can fix most problems on the LDV Maxus that occur with faults to do with the Central locking/fobs/ESA/ETACS - three relays are in the ESA and they control ONLY the central locking - two more relays are in the ETACS unit (behind the ashtray) and they control the fogs and intermittant wipers.

Any help or info needed please contact info@remobilise.co.uk
or tel 01792 896404.

We are based in Swansea UK.

Aug 30, 2012 | Cars & Trucks

1 Answer

Ldv maxus fault code p0402


Airbag warning light goes out on starting but comes back on after about 5 seconds

Jun 14, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...