Crankshaft Position (CKP) Sensor (LZE/LZ4/LZG)
center of the engine block ( the side closest to the fire wall )
Testimonial: "I just put a new one on there I can spray starter fluid in it and it will start up and cut back off"
SOURCE: crankshaft position sensor location
1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition
coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor
A
magnetic crankshaft sensor (Hall Effect switch) is used which is
remotely mounted on the opposite side of the engine from the DIS/IC
module. The sensor protrudes in to the engine block, within about 0.050
in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
Testimonial: "Awesome. Thanks."
SOURCE: location of crankshaft sensor on a 98 chevy s10
It is located on the passenger side of the engine block just under the ignition module you can see it from underside. The easiest way to see it and access it is to jack up the passenger side front wheel and take the wheel off there is a rubber flap in the wheel well you can push out of your way. I am warning you be very careful removing it mostly made of plastic I broke one off leaving most of the sensor in the engine block had to drill the rest of it out which was no fun not alot of room for you to work. Get yourself a bottle of PB Blaster and keep spraying it as your pulling out before you try pulling out the sensor try to get it free enough that you can spin it around. Hope this helps good luck it fits pretty tight!
SOURCE: 02 chevy silverado crankshaft sensor location
my 94 chevy truck stalls even at highway speed ,it starts again but stalls after a few secs, finally it will run for awhile before it stalls again
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
1,134 views
Usually answered in minutes!
×