Question about Cars & Trucks

1 Answer

Where is the fan heater resistor fitted on a ldv maxus van

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 8,546 Answers

Hi terry.
see if this link helps you out,just scroll down the page might help you.
Where is the fan heater resistor fitted on ldv maxus van Google Search

Posted on Nov 03, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ftw1952

frank thomas wilson

  • 10319 Answers

SOURCE: '97 Venture Van. Fan is not blowing no matter

Test the motor first, The wire to it is a hot positive wire and the motor's housing is the ground. If that works ok next check the resistor to see if its burnt out. Did you look at your fuses first?

Posted on Jan 12, 2010

Anonymous

  • 2 Answers

SOURCE: i have a 55 maxus ldv van. i have problems

sounds like it could be the pressure control valve on the fuel pump not an expensive repair. the pressure drops in the line over night. try priming the filter whilst the engine is being cranked. the control valve is held on by 3 torx screws on the end of the pump.

Posted on Feb 26, 2010

SOURCE: ldv maxus wont start off key but goes with a push everytime

You could check your battery if its properly charged then check your alternator, probably d alternator is bad and doesnt charge the battery wel enough. So its either your alternator or ur battery. Also try removing a batt terminal after each drive to avoid draining

Posted on Jan 29, 2012

narlock_ald

Al Narlock

  • 81 Answers

SOURCE: 2007 ldv maxus 2.5 van will only start with easy stast and it comes up with 1 fault crank position sensor

next would be to check the fuel pressure at the fuel rail (under hood @ fuel inj sight) It sounds more like a fuel delivery problem then an electial problem

Posted on Jun 03, 2012

emissionwiz

Marvin

  • 85222 Answers

SOURCE: error code 0734,at my car LDV MAXUS 2,5! The motor no power

P0734 - Gear 4 Incorrect ratio
Possible causes- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit problems

Posted on Oct 25, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

08 ldv maxus 3.5 t 2.5 diesel Where do I locate the blower heater resistor Thanks


its in the air intake ducting/ truncking behind the glovebox going to the heater/climate unit behind the dash/glovebox

Nov 17, 2017 | Cars & Trucks

1 Answer

Today i bought ldv maxus van 3.5 2005 keeps jumping out 4th gear


will assume a used van
any warranty ? go back to place of purchase

if a manual ..worn syncros or adjustment to shifter cables

if an automatic a shift soleniod or worn drive clutches

26308726-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Oct 12, 2016 | Cars & Trucks

1 Answer

Vibration shudder


get tires rebalenced if that doesnt fix it check all cv joints / u joints make sure thay are good

Nov 27, 2013 | Cars & Trucks

1 Answer

How to fix 5th gear on my ldv maxus


Its likely you have a problem with the clutchnot completly disengageing or problems with disk or pressure plate

Jun 13, 2013 | 1997 Chevrolet Cargo Van

2 Answers

Help!!! how to reset a LDV Maxus key fob?


Hi
I know from experience that you cannot really re synch these fobs on the LDV Maxus vans.
What actually is the fault is an onboard component on the pcb has failed and we normally just replace that with a new one..the fob will be tested for operation and sent back. OR its the Relay in the ESA unit - under the left hand front glovebox on the bulkhead - black with cables going into it. We have those relays (soldered to the pcb) we can supply those or do the work for you. The fob connects to that ESA and the unit then fires the relays to open/close the doors. Sometimes that unit is installed upside down which causes water (condensation) to enter the box and have fun with your electrics.
The fob is SYNCHED to this unit via coding we can use your old fob to clone to a new fob and that will work with the ESA and the vehicle.
We have the parts on this link Items for sale from remobilise ltd

Here is a link to how to program the fob to the vehicle via the programmer - NOTE how you MUST have a working fob to program another (text at the start of the video... LDV Maxus flv

We can fix most problems on the LDV Maxus that occur with faults to do with the Central locking/fobs/ESA/ETACS - three relays are in the ESA and they control ONLY the central locking - two more relays are in the ETACS unit (behind the ashtray) and they control the fogs and intermittant wipers.

Any help or info needed please contact info@remobilise.co.uk
or tel 01792 896404.

We are based in Swansea UK.

Aug 30, 2012 | Cars & Trucks

1 Answer

2007 ldv maxus 2.5 van will only start with easy stast and it comes up with 1 fault crank position sensor


next would be to check the fuel pressure at the fuel rail (under hood @ fuel inj sight) It sounds more like a fuel delivery problem then an electial problem

Jun 03, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

365 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...