Check this link might help you find it.
Where do find heater resistor fitted on ldv maxus Google Search
It is located above fan, which you will have to remove and remove glove box and shelf above.
Disconnect plug twist out very stiff, once removed i replaced with a much cheaper ford focus resistor for less than £10 you will need to cut off old connector and replace each wire with a 25 amp spade connector. Tape each connector to insulate each one to get the right colours for right speeds are as follows. Although the focus resistor is of a different shape it will work tape up with electrical tape to avoid any shorting out the resistor side completely, looking at back of resistor as follows you will have two fixing points one at bottom Left one middle right. So wiring top left Purple top right Red/white, Bottom left brown bottom right Red Yellow. Now place resistor back inside hole.
The 25 amp spade connectors purchased from Halfords.
Resistor from E-bay
SOURCE: ldv maxus wont start off key but goes with a push everytime
You could check your battery if its properly charged then check your alternator, probably d alternator is bad and doesnt charge the battery wel enough. So its either your alternator or ur battery. Also try removing a batt terminal after each drive to avoid draining
next would be to check the fuel pressure at the fuel rail (under hood @ fuel inj sight) It sounds more like a fuel delivery problem then an electial problem
SOURCE: error code 0734,at my car LDV MAXUS 2,5! The motor no power
P0734 - Gear 4 Incorrect ratio
Possible causes- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit problems
SOURCE: 56 plate LDV Maxus, right hand indicator makes the rear fog lights flash along with the indicator
Hi,when this happens its normaly falty bulb or falty lamp holder which is creating bad earth,to find out if its a bulb swap all the bulbs at the back, so take the bulbs from left and put them in right and vicer vercer,if still blinking then take the board to have tested.
hope this was some help.
407 views
Usually answered in minutes!
×