Have a Tahoe 7000 diesel ,runs great except when you turn on breaker with no load. runs about 7 to 10 seconds and shuts down, Can you help

SOURCE: MAH 3000 Maytag front loading washer-shuts down

Check with Maytag (Whirlpool) board problem.

Francisco Cortes

• 781 Answers
• Posted on Sep 20, 2008

SOURCE: ibm netvista shuts down on start up

1. if possible check and see how dusty the system is inside.. used compressed air cans to dust it off.. don't touch any components... watch esd so ground yourself while you're at it
then test
2. you're power supply may be dying: ground yourself to the same ground as the computer (watch for esd) and replace the powersupply.
then test.
the keyboard or controller may be damaged, check for resource conflicts in your bios related with keyboard (make sure no other items are using the same irq's.. check plugs, test with other key board.. replaced motherboard.
random shut down could also mean that the cpu is overheating.. make sure the cpu fan is undusted and working.

SOURCE: Sumsung MU3250W shut down

The problem is your magnetron tube is leaking RF. The mag tube comes on 2-3 seconds after you hit start, and the RF interfears with the board and shuts it down. Drop the front of the control panel down and watch, it wont happen.. Get a new mag tube put in and you'll be good to go.

SOURCE: 1996 Chevy Tahoe- replaced pcv valve, air cleaner,

have you checked the tps sensor?

SOURCE: yamaha 6500 watt diesel runs but usually shuts

First thing to monitor is the fuel solenoid power. See if it is the thing that goess away to cause shutdown.

Tracing this back there is only a few things that control this: The battery, the low oil shutdown switch, and the run switch, and associated wiring.

If I were to ventture a guess, I would put money on the low oil shutdown switch.