My 2008 pt won't let me change from metric to us

go to setting in the main menu marked i on your dash

To change display to a Metric or English reading, press and hold the RESET & MODE buttons for 3 (three) seconds...Good-Day! It should be listed in your owners manual under driver information center ( DIC )

I think the rear windows are designed to only go down so far as the body design of the rear doors won`t allow them to completely go down. the doors are a different shape than the front doors.

14 mm (Front)

You have no metric tools?

There is You Tube Video on doing your brakes

My PT did that when my timing belt broke. It cost $500.00 to replace it. If it is broken, be ready to have some motor work done. I had to have to values replaced at a cost of $900.00. If your timing belt is not broken then check the alternator and battery. I was riding down the road and my PT shut all the way down and would not start. I had to leave it beside the road. It was my alternator. It gave me no warning.

sounds like the switch cluster

Not too difficult to do it right there apparently

http://www.ehow.com/how_5833657_replace-serpentine-belt-pt-cruiser.html


http://www.decor-styles.com/car-styles/Replace-a-Serpentine-Belt-on-a-PT-Cruiser.html

Disconnect the battery for 90 seconds, then unplugged the cluster.. Then connect the battery with no cluster.. HVAC display changed to metric...

Re-connected the cluster again, display changes to imperial...

The cluster is what dictates what is displayed. It is metric by-default but a US imperial instrument cluster overrides that.

You should replace the oil every 3,000 miles or 3 months. Unless you are using synthetic oil. With synthetic you can go to 10,000 miles. But I change mine at 7,500.

nope