Belt routing for a 2012 Dodge Avenger 2.4L - 2012 Dodge Avenger

SOURCE: Serpentine/drive belt routing diagram of a 2002 dodge Intrepid needed.

Try this web sight. http://www.dodgeintrepidchat.net/02lhe/

SOURCE: diagram for a serpentine belt replacement for 2000 avenger dodge

HI. i have posted the diagram requested below.

Testimonial: "This was exactly what we needed, Thank you so very much. "

SOURCE: 2006 Dodge diesel belt routing diagram

Here's a link to the diagram you need...

http://www.gates.com/common/part_locator/view_diagram.cfm?id=S8023

Testimonial: "Awesome! thank you so much for the quick response!"

Greg Bernett

• 2993 Answers
• Posted on Oct 29, 2009

SOURCE: 1998 Dodge Avenger serpentine belt issue

What size of motor, do you have a/c and which belt are you replacing? Not sure about your engine size since you did not list it so please pick the applicable motor:

Sebring Coupe And Avenger (2.5L VIN N Engine)

1. Disconnect the negative battery cable.
   
2. Loosen the tension pulley locknut.
   
3. Rotate the adjusting bolt to decrease the belt tension.
   
4. Remove the drive belt from the engine.
   

1. Position the replacement belt around the pulleys, making sure the belt routing is correct.
   
2. Adjust the belt by rotating the adjusting bolt until the correct tension is reached. Refer to the procedure earlier in this section for belt adjustment.
   
3. Once the desired tension is reached, secure the locknut. Recheck the belt tension.
   
4. After the belt is installed and adjusted properly, tighten the locknut to 17 ft. lbs. (23 Nm).
   
5. Connect the negative battery cable.
   

1. Disconnect the negative battery cable.
   
2. Loosen the tension pulley locknut.
   
3. Rotate the adjusting bolt to decrease the belt tension.
   
4. Remove the drive belt from the engine.
   

1. Position the replacement belt around the pulleys, making sure the belt routing is correct.
   
2. Adjust the belt by rotating the adjusting bolt until the correct tension is reached. Refer to the procedure earlier in this section for belt adjustment.
   
3. Once the desired tension is reached, secure the locknut. Recheck the belt tension.
   
4. After the belt is installed and adjusted properly, tighten the locknut.
   
5. Connect the negative battery cable.
   

SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan

3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!