Chevy cavalier 2.2 4 cylinder 2005 where is oil filter located.

Question edited for clarity.
Question moved to model category.

In the link

https://www.google.com/search?q=2005+chevy+cavalier+ls+2.2+fuel+line+diagram

..

https://www.bing.com/videos/search?q=Location+of+the+oil+pressure+sensor+on+a+2004+Chevy+cavalier+2%3a2+eco+tech+engine&FORM=HDRSC3

Get a large pan to catch the oil. Place it under the engine where the filter is located. Turn the filter counterclockwise and remove. Reverse the procedure.

by the oil filter 8mm bolt holds it in.

to the left of the oil filter.

The oil filter is ontop of the engine underneath the engine cover down by the right side of the intake manifold you will see a black cap with a nut on it i believe it is a 36 mm when you loosen that cap the filter is under that, it is a cartridge style filter.

Your oil filter is located on the right side underneet the power steering oil. Its a black cap with a square notch on it to remove it.

Hope helps (remember to rate and comment this).

Actually, the Torque Converter Clutch Solenoid is located within the transmission housing that is easily accessible through the transmission oil pan. The TCC solenoid may vary in location dependent upon manufacture but generally it is located as aforementioned. It can cause your vehicle to stall if stuck open or close because it controls loads to the engine via your torque converter which is located between the vehicle's engine and transmission. Also, make certain that you attempt to change the transmission fluid and filter before changing the TCC solenoid because that may be your underlying issue. If not, simply reuse your fresh oil and change the TCC soleniod.

ECOTec 2.4 Liter engine (and all ECOTec engine blocks in 4 cylinder sizes) have a cartridge type oil filter housing on the front of the block, driver's side of the vehicle.

The cap must be removed with a wrench, and the filter pulled out, then the new one put in. Now is usually a good time to replace the O-ring on the cap.

code 13 is the oxygen sensor code 24 has to do with the MAP sensor